Battery Charger & Tester 3500

Battery Charger & Tester 3500
Double function: Battery Charger & Tester of the Battery on board.
Automatic with Microprocessor, 6 Charging Cycle:
Initialization, Soft Charge, Bulk Charge, Desulfation/Absorption(Recovery of the Lead-Acid cells), Maintenance, Battery Analysis (EndCycle Test).
Maximum Charge Current: 3.5 Amp.
Back-lightened LCD Display indicating the Cycle executed, the BatteryState-Of-Charge (digital Voltmeter) and any occurring anomalies inreal-time
Automatic and guided test procedure: Battery Test in Null-loadcondition, Battery Cranking Power Test at the engine Start-Up +Alternator/Regulator Test.
For all 12V lead-acid batteries (traditional, Gel, MF, AGM, VRLA...) from 15 to 150 Ah.
BATTERY CHARGING WORKING MODE
In case of regular functioning, the LCD Display shows the following messages:
- "BATTERY IN ... CHARGE": Soft & Bulk Charge under execution.
- "BATTERY IN ... DESULF.": Desulfation Cycle under execution.
- "BATTERY IN ... MAINTEN.": Maintenance Cycle under execution.
- "BATTERY IN ... VERIFY": End Cycle Test under execution.
In case any errors occur, the LCD display will show diagnostics messages until the problem is solved.
TESTING WORKING MODE

To activate the TestingWorking Mode, just connect BC 3500 to the battery and not to the 220VPower Outlet. The Display will show you all the instructions to followduring the procedure.

1. Testing the Battery in Null-load condition: it measures the battery voltage in null-load condition and it provides an estimate of the battery State-of-Charge.
2. Testing the Battery Power during the engine Start-Up:it measures the battery voltage during the engine start-up (CrankingVoltage) and its duration in milliseconds, evaluating the condition ofthe battery.
3. Alternator/Regulator Test: it verifies the correct functioning of the vehicle's charging system to check if it’s able to recharge the battery.Made in Italy